Skip to content
  • There are no suggestions because the search field is empty.

The channel map bars are not responding in the RubiQ Configurator.

If you have already tried re-binding the receiver, the RX may be in the wrong mode.

During the RubiQ Configuration process, when you are verifying RX channel mapping, if the bars in the RubiQ configurator do not respond:

  1. Return to Step 1 of the Configuration Guide and rework through the binding process.

  2. If you continue to experience issues, check that you’re operating on the correct version of the RubiQ Configurator. You must download the RubiQ Configurator directly from the Download Configurator step.
  3. If you are still unable to bind the RX, check the LED under the 3D-printed tray mount. If the light is blue, then your RX is in the incorrect binding mode. This occurs if the bind button is held down for too long during binding. To fix this:
    1. Reconnect the LiPo battery to RubiQ.
    2. Press and hold the BIND button for at least 5 seconds.
    3. Release the button.
    4. The receiver’s blue LED will blink three times and turn off, indicating that the receiver has been reset to PPM mode. You can then retry the binding process from Step 1.